All Parts
Rubber charging port cover with eGO logo for the eGO Cycle electric scooter. Protects the AC inlet charging plug connector and keeps unwanted thingsMore Info
This part attaches to the eGO Cycle's front dash and the AC charger cable plugs into it. There is a round rubber AC inlet cover that protects itMore Info
Power cord for eGO Cycle electric scooter sold in the USA. Plugs from any standard AC wall outlet directly into your eGO Classic or LX dash. ThisMore Info
eGO Cycle axle nut for front and rear wheels. This is the outermost axle nut that is used to tighten the wheel to the front forks or frame. It fitsMore Info
Battery charger fuse for the eGO Cycle electric scooter with 5 Amp Schauer battery charger. This is the fuse that is located on the battery chargerMore Info
Battery charger fuse for the eGO Cycle electric scooter with 7 Amp Schauer battery charger. This is the fuse that is located on the battery chargerMore Info
Battery charger harness fuse for the eGO Cycle electric scooter. This is the positive wire fuse that is between the battery charger and theMore Info
Battery hold-down strap for the eGO Cycle electric scooter. Tough nylon belt strap with adjustable side release buckle. If this part fails then it isMore Info
Battery indicator gauge with ten segment red LED display for the eGO Cycle. Dash-mount. Indicates the battery charge level when the scooter is atMore Info
Set of two battery terminal covers for the eGO Cycle electric scooter. One red and one black terminal cover is included with the set.
eGO Cycle electric scooter battery. 12V 35Ah. Make sure to order two of these batteries because both of the batteries in the eGO battery pack shouldMore Info
eGO Cycle electric scooter primary drive belt. This is the belt that goes from the motor pulley to the jackshaft pulley.
eGO Cycle electric scooter secondary drive belt. This is the belt that goes from the jackshaft pulley to the rear wheel pulley.
Headlight bracket for eGO Cycle. Holds the headlight to the front fork. L-shaped aluminum alloy design. Old part number: 470-7005
Mounting bracket for holding the round red LED brake and tail light of the eGO Classic model. We also carry the Round LED Taillight that thisMore Info
Copyright © 2025 eGO Vehicles.